RE: [rtl] Programming a FPGA

["Heinicke, Eric" <eric.heinicke@baesystems.com>]

Title: Programming a FPGA

We are using an Altera part on a home grown board.  Previous to this, any work of this type was done on platforms without an OS and with the device image in an EEprom.

 

Any information you are willing to share would be most appreciated!

Thank You.
 
Eric O. Heinicke       eric.heinicke@baesystems.com
BAE SYSTEMS         Voice:631.262.8644
                       Fax:  631.262.8657
                       One Hazeltine Way, MS 1-78
                       Greenlawn, NY 11740-1606

 

-----Original Message-----
From: Tobias Klotz [mailto:tk2@njit.edu]
Sent: Monday, October 09, 2000 18:58
To: Heinicke, Eric
Subject: Re: [rtl] Programming a FPGA

Which hardware do you use? We used a Constellation Flex Board and implemented a little program to flash the FPGA Board with our Design (.ttf) file after booting. The Protocoll is simple, if you need you can get details or perhaps the program!

 

tobias

----- Original Message -----

From: Heinicke, Eric

To: 'rtl@rtlinux.org'

Sent: Monday, October 09, 2000 3:05 PM

Subject: [rtl] Programming a FPGA

Does anyone know of any driver code that shows the programming of a FPGA on the target device board, from a file on the system disk?

Thank You.
 
Eric O. Heinicke       eric.heinicke@baesystems.com
BAE SYSTEMS         Voice:631.262.8644
                       Fax:  631.262.8657
                       One Hazeltine Way, MS 1-78
                       Greenlawn, NY 11740-1606