[rtl] Reply to ancient post: servo control.

[Rob Browning <rlb@cs.utexas.edu>]

I just joined the list and I'm going through the archives trying to
see if any of my initial questions are answered there, and I came
across an ancient question about controlling servos from linux.

For anyone still interested, Scott Edwards Electronics sells a small
board (about an inch square http://www.seetron.com/ssc.htm) with a
serial interface that'll controll up to 8 servos.  It can daisy chain
with other boards to control up to (I think) 255 servos.  The serial
protocol is trivial, and the board is (as I recall) under $50.

Hope this helps.

-- 
Rob Browning <rlb@cs.utexas.edu> PGP=E80E0D04F521A094 532B97F5D64E3930
--- [rtl] ---
To unsubscribe:
echo "unsubscribe rtl" | mail majordomo@rtlinux.cs.nmt.edu OR
echo "unsubscribe rtl <Your_email>" | mail majordomo@rtlinux.cs.nmt.edu
----
For more information on Real-Time Linux see:
http://www.rtlinux.org/~rtlinux/